I am replacing the wheel bearings and seals on my FF 14BT. Was wondering if it would be beneficial to pack the bearings with a non synthetic grease. Seems to me it would be, but want to hear from others.
You dont need to pack them like a axle brg. Just a coating. Then tilt the axle way up to either side for a few min.
Check diff fluid lvl afterwards
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Pirate 4x4
18.7M posts
366.7K members
Since 2000
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!