Re-Arching Springs

[NorcalVP]

In Nor Cal where's the best place to get some springs rearched... i am going to be installing some 63 inch chevy's in the back of my tacoma and i will need to rearch the springs to about 6 inches of lift (maybe more) and cost is an issue (i am a brokeass mofo)

[UGET IT]

A good place to go is Betts Spring in San Leandro, 510-633-4500 or get the number for A-1 spring in Oakland.

[NorcalVP]

Originally posted by Kevin:
<STRONG>A good place to go is Betts Spring in San Leandro, 510-633-4500 or get the number for A-1 spring in Oakland.</STRONG>

What kind of price should i be looking to pay?

[UGET IT]

Call and ask.........I know my brothers had a wrangler set done and it was something like $120.00???????? There also make custome spring packs.

[The Rockslut]

Originally posted by Scout Dude:
<STRONG>Betts is also in West Sac. I don't know the number though....</STRONG>

Lotta help this guy is! <IMG SRC="smilies/thefinger.gif" border="0">

[NoBrainR]

I've heard of guys re-arching they're own by taking the leafs apart and beating them with a hammer. But I'm not totally sure of the proceedure, how much you gain, or how long it last's. Re-arching definately makes them stiffer though. I'll see what I can find out though.

[NorcalVP]

anyone know what's the most lift i can get out of stock chevy's?

[NoBrainR]

Disclaimer: This is not from first hand experience, but from someone who has done the re-arching himself, my father.

You need a sledge (4 lb will do) and an anvil, piece of rail iron, or the like. You'll need to know approximately how much additional arch (lift) you want in the springs. Separate the spring into it's individual leafs. Trace the main leaf on the floor to give yourself a reference to work from. Now you'll want to strike the inside arch of the spring, the outside being against the anvil, working your way down the length. Try to keep centered. If you get off to the side, the spring will start to twist, but you can correct this by striking the opposite side of center from your last strike, or the one that started the twist. I would also put reference marks, say every 4 to 6 inches, down the inside so you could repeat it on the other spring. After each pass down the spring, compare it to your reference, and you'll see the difference. Once you get the desired arch on the main, do the same to the other leafs, matching them to the arch on the main.

I'm remember my dad doing this on his 66 CJ and he went too far, actually reversing his shackle angle. The more arch you put in them the stiffer they'll get. So don't over do it. And guarenteed, it's going to take some elbow grease. But it's the cheapest method I know.

[CRAWLR]

Me and a friend of mine did his CJ springs with a press. Just gave them a little bump every two inches all the way down each leaf. He gained about 3 inches and it lasted longer than we expected but they did eventually flatten back out. Just be careful at the center. They bend real easy at the center pin hole.

[IMUZ ME]

Is this a serious question? You've been getting plugged in the starfish way too much.