Pirate 4x4 banner

Backlash ?

418 views 5 replies 4 participants last post by  Nobody 
#1 ·
Is the backlash suppose to be EXACTLY the same all the way around the ring Gear? Or can the backlash vary just as long as it is within the range.

This is a Ford 9" and I am getting AT most 11 and at least 7 and its not like the 11 and 7 are on opposite ends.



Then how tight do the lash adjusters need to be? As tight as i can get them?
 
#4 ·
Maximum Backlash Variation Between Teath: .003
Backlash : .008-.012


Hope this helps.


Eric
 
#5 ·
the gears are from a junk yard but there is a tag on the Pumpkin where they had been replaced so who knows.... I figured that was better than stock so they are less than 20 years old....

well i figure .004 ain't bad i'll mess with it a bit more and then i'll run it... just as long as the detroit don't get gernaded i'll be cool with it
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top