Pirate 4x4 banner

Dana 60 Steering Arm Fab ?

827 views 4 replies 4 participants last post by  DavidO 
#1 ·
Hi,

I will be fabbing up my Dana 60 steering arms soon. I'v got almost everything figured out except fabbing the "dome" for the king pin spring. I'v seen some that sit ontop of the stamped cover. Is thare some pre-fabbed part out there that lends itself to this application?

Thanks
 
#3 ·
check your local pipe supply house - you can find a weld on pipe cap that I have seen more than one set of arms use....
 
#5 ·
I think you can either reuse the cap that's on there, or go to the Chevy house and pick up some new ones. I don't think you have to fab anything but the puck that goes inside of it. I haven't replaced mine yet, but this is what I understand from the reading and looking at kits.

I'd look into it more before you go off on the deep end fabbing something that you don't need.

~dso
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top