Pirate 4x4 banner

Hub OD

564 views 3 replies 3 participants last post by  RustoleumWhite 
#1 ·
i recently aquired a 60 from a old 1 ton pickup . i cant get to the axle at the moment so im looking if someone has any info on the axle like the hub OD its a 6 bolt flange axle insted of the 8 but an 8 lug wheel hub. Im looking to fit 15" 6 lug wheel ( redrill blahblahblah) Its a dually 65" wms with stock 4.56 gears 30 spline shafts.
 
#4 ·
Actually it sounds like a "standard" 8-lug, D60 FF from an later model IH pick-up

6 bolt flange axle insted of the 8 but an 8 lug wheel hub
sounds like 6-bolt axle flange rention, 8-lug bolt pattern.

As for re-drilling it to 6-lug, I don't know, as for getting the center hub through a standard 6-lug wheel center... I don't think so. "Normal" thought is that D60 hubs are too big in Dia. to fit through a smaller than 8-lug wheel center, and the IH D60 hubs are pretty fat.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top