Pirate 4x4 banner

32 spline Dana 300 output

1K views 4 replies 4 participants last post by  onetoncv 
#1 ·
Does anyone have any experience with running an output yoke that will fit a 1350 CV or non-CV rive shaft. Advanced adapters tells me that it cant be done, but I dont see whay you couldnt take an NP 205 output yoke and have the shank machined to fit the seal. Also there is an article in this months JP where theyt put the yoke on with this kit, but they dont mention any issues...


Anyone try it with a 1410?:p

Thanks,

Ryan
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top