About an inch space at rest...seemed like about 1/2 - 3/4" at full droop. Thinking about making some 1/2" blocks to go under those arms...but will wait to see what happens on the first run.
The TRE's are '85 Blazer TRE's. 7/8-18 thread. The tubing is not MORE tubing any longer. I am using that stuff for my anti-wrap bar now...look for that post later tonight (just finished it).
The tie-rod and drag link tubes are actually '85 Blazer tie-rod tubes. They are tapped left hand and right hand already. I just cut them down to length on the right hand side (since left hand taps in that size are hard to find). Then tapped the cut down end with 7/8-18 right hand thread.
Sweet arms, know anyone running relocated arms (other than M.O.R.E.) on TJ 30 outers. I have a custom setup which is working great but would like to improve on it a bit. I need to get the holes in the knuckles out further to run a tie-rod knuckle to knuckle that will clar my diff (44 housing w/ 30 kunckles).
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Pirate 4x4
18.7M posts
366.4K members
Since 2000
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!