Is anyone still running it or did they swap it for the nv231 long time ago. What about the rear axle ditch it for a cherokee d44 or get a yota axle, I have the 84 cherokee
It's out of an '87 YJ (Yes, an '87. They switched to the 231 for the last run of '87 models produced). 21-spline input gear.
It's got a Currie SYE kit installed which uses a drive flange on the rear output.
$450/BO and I'll throw in the 1310 C-V driveshaft with matching flange. (C-V assembly needs a re-build, but is otherwise O.K) Approximately 17 inches long at the center of travel (jeep parked on flat ground)
This case lived a cushy life behind a ball-less 258 and has never failed to function flawlessly. It was removed to make way for bigger, better things when I did my Ramjet 350/NV4500/NP241 swap.
You pay to ship. Pay Pal Preferred.
E-mail me offline if you're interested.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Pirate 4x4
18.7M posts
366.4K members
Since 2000
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!