Ignition Box install - Pirate4x4.Com : 4x4 and Off-Road Forum

Doc Holiday13 · 01-15-2006, 11:17 AM

'm putting in my new ignition box today. Its a Procomp 6al (basically same as the msd 6al http://cgi.ebay.com/ebaymotors/Proco...QcmdZViewItem)

My wiring problem is this. There are the two wires for the battery, coil, and distributor. There is another wire the 12 volt switch, a wire for amplifier output(it basically isn't used) and there is a third wire labeled for the tach. The directions on this thing aren't of any help

First off there are three wires coming out of my distributor-orange, violet, and black. Do I just cut the orange and violet and wire straight in to them and leave the black alone??

Secondly where do I wire the green wire into??

This is on a 90 Wrangler with 258.

Doc Holiday13 · 01-15-2006, 07:35 PM

anybody???

01-15-2006, 11:17 AM	#1 (permalink)
Doc Holiday13 Registered User Join Date: May 2005 Member # 48233 Location: Northern VA Posts: 3,155	Ignition Box install 'm putting in my new ignition box today. Its a Procomp 6al (basically same as the msd 6al http://cgi.ebay.com/ebaymotors/Proco...QcmdZViewItem) My wiring problem is this. There are the two wires for the battery, coil, and distributor. There is another wire the 12 volt switch, a wire for amplifier output(it basically isn't used) and there is a third wire labeled for the tach. The directions on this thing aren't of any help First off there are three wires coming out of my distributor-orange, violet, and black. Do I just cut the orange and violet and wire straight in to them and leave the black alone?? Secondly where do I wire the green wire into?? This is on a 90 Wrangler with 258. Last edited by Doc Holiday13; 01-15-2006 at 11:18 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

01-15-2006, 07:35 PM	#2 (permalink)
Doc Holiday13 Registered User Join Date: May 2005 Member # 48233 Location: Northern VA Posts: 3,155	anybody???