YJ Tranny Q - Pirate4x4.Com : 4x4 and Off-Road Forum

Yota Tony · 05-31-2006, 08:36 AM

I've got an AX-15 and np231 from a 94 YJ sitting here.
What I'm wondering is, it should be an external slave cylinder correct? I don't see a slave cylinder mounted on it so I'm guessing it's been removed.

muddyj · 05-31-2006, 09:44 AM

I don't remember which years had the external slave cylinder for sure, but on my 93 YJ, which also has the AX-15 and 231, it has a hydrolic throw out bearing. there is just a little rubber plug with a hydrolic line going through it, where the clutch fork(if equiped with an external slave) would go through the bell housing

jesster · 05-31-2006, 09:50 AM

I thought the external slave cylinders were only on some of the 95 YJ AX-15's, but I may be wrong...

Edit:

I was...

PhatXJ · 05-31-2006, 11:46 AM

'93- was internal, '94+ was external.

Yota Tony · 05-31-2006, 08:20 PM

Quote:

Originally Posted by PhatXJ

'93- was internal, '94+ was external.

Awesome, that's what I wanted to hear.

05-31-2006, 08:36 AM	#1 (permalink)
Yota Tony Registered User Join Date: Nov 2004 Member # 39045 Location: The Rock Posts: 1,092	YJ Tranny Q I've got an AX-15 and np231 from a 94 YJ sitting here. What I'm wondering is, it should be an external slave cylinder correct? I don't see a slave cylinder mounted on it so I'm guessing it's been removed. __________________ Anthony

05-31-2006, 09:50 AM	#3 (permalink)
jesster Registered User Join Date: Jun 2005 Member # 49468 Location: Rogersville, TN Posts: 1,404	I thought the external slave cylinders were only on some of the 95 YJ AX-15's, but I may be wrong... Edit: I was... Last edited by jesster; 06-01-2006 at 06:40 AM.

05-31-2006, 11:46 AM	#4 (permalink)
PhatXJ Registered User Join Date: Aug 2001 Member # 6562 Location: Eastern WA Posts: 162	'93- was internal, '94+ was external. __________________ 3/4 Ton YJ

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-31-2006, 09:44 AM	#2 (permalink)
muddyj Registered User Join Date: May 2006 Member # 72752 Location: the hub of the universe A.K.A. Boswell, IN Posts: 170	I don't remember which years had the external slave cylinder for sure, but on my 93 YJ, which also has the AX-15 and 231, it has a hydrolic throw out bearing. there is just a little rubber plug with a hydrolic line going through it, where the clutch fork(if equiped with an external slave) would go through the bell housing