so yes i am new to setting up gears and i decided to give it a shot. please give me your opinions on this pattern and whether you would run this set up or not. Also, im sure it isnt "perfect" but is it at least an acceptable pattern. I really dont want to tear this thing down again!
This is an xj dana 44 rear with an arb and yukon 4.88 new gears.
pinion preload is set at 17 inch pounds (according to yukons install manual 16-19 is okay)
backlash is .007-.008 throughout the gear runout. (again yukon specifies btwn .006-.010)
hope the pics arent too blurry as my camera is not the best.
thanks in advance.
Drive side
Drive side
Coast side
coast side
This is an xj dana 44 rear with an arb and yukon 4.88 new gears.
pinion preload is set at 17 inch pounds (according to yukons install manual 16-19 is okay)
backlash is .007-.008 throughout the gear runout. (again yukon specifies btwn .006-.010)
hope the pics arent too blurry as my camera is not the best.
thanks in advance.
Drive side
Drive side
Coast side
coast side