Pirate 4x4 banner

info about rod-end, heim joint etc...

811 views 4 replies 4 participants last post by  burrellsjeep 
#1 ·
I'm planning to do my very first custom suspension...4 link long arm on my 98' jeep TJ and I have no idea about what rod-end or joint I should use...

The jeep will be my extreme daily-driver, so I need rod-end or joint that won't loose after 10k km and have sick flex :smokin:

I need some suggestions :D
 
#5 ·
I used 3/4 heims with High misalignment spacers reducing it down to 9/16 bore (9/16 is the factory bolt size), The johnny joint rod end is very nice and they can be rebuilt if they wear out. Check out www.Ballisticfabrication.com they have a good selection for comparable prices.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top