Pirate 4x4 banner

Custom Auto Trans Mount

707 views 1 reply 2 participants last post by  astjp2 
#1 ·
I'm in the middle of stretching my CJ7, going full width and adding an automatic transmission(tf 727). Just looking for ideas on how some of you guys built your trans mount/crossmember. I want to build a custom belly pan also and trying to incorporate it with the crossmember. Before all you WEB RANGERS blast me for not searching, I have and not found exactly what I'm looking for. So If you have ideas or pics, post up, if you want to flame:mad3:, go elsewhere please. thanks:D
 
#2 ·
You might run into problems with the front shaft hitting the side of the tranny, I used the stock crossmember since I had a 999 and it was a problem. If you outboard your springs and get the front yoke a little farther outboard it should clear. After that, any flat skid plate you can fabricate should work. Tim
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top