I have searched up and down for detailed write ups on the nutter mod for the 4 banger. Most threads I find are not there anymore or have little to no actual technical direction just confirming they have done it. This is were i currently am at:
-Opened main wire loom looking for "purple and orange" wires the ones i found led to the sensor for my thermostat and the orange went to some emissions crap
-Looking at my distributor I see no way to wire anything to it at all although there is a ridge in the bottom of my cap where the wires may run? Do i need to do the ford HEI cap swap to wire this up correctly ?
-Im pretty sure I have the YFA carb, was told i may want to swap to YF due to the complexities in adjusting the YFA
The process ultimately doesn't seem like its terribly hard i would appreciate if anyone who has done it could point me in the right direction thanks a lot
(didnt post in hardcore figured i would try here first since 4 bangers are quick to get flamed )
Thanks again:smokin:
-Opened main wire loom looking for "purple and orange" wires the ones i found led to the sensor for my thermostat and the orange went to some emissions crap
-Looking at my distributor I see no way to wire anything to it at all although there is a ridge in the bottom of my cap where the wires may run? Do i need to do the ford HEI cap swap to wire this up correctly ?
-Im pretty sure I have the YFA carb, was told i may want to swap to YF due to the complexities in adjusting the YFA
The process ultimately doesn't seem like its terribly hard i would appreciate if anyone who has done it could point me in the right direction thanks a lot
(didnt post in hardcore figured i would try here first since 4 bangers are quick to get flamed )
Thanks again:smokin: