Pirate 4x4 banner

4.10 Carrier in 3.07 D30? Aussie Q

926 views 5 replies 3 participants last post by  Fudpucker 
#1 ·
I'd like to make a quick parts swap for this weekend if i can :
I need to go light wheelin in a 3.07 geared XJ on 31"s.
I've got a 4.10 D30 waiting to go under it which has an Aussie locker installed. Can i just put the complete Aussie installed carrier from the 4.10 axle into the 3.07 housing?

I seem to remember something about 3.07 and 4.10 being different and non interchangeable somehow but would the carrier be physically different?

Any help would be greatly appreciated guys, i gotta set this turdy up today.
 
#5 · (Edited)
The carriers will swap between the axle housings, but the 3.07 gears will not work on the 4.10 carrier.
If you are that pressed for time then can you "lincoln lock" the 3.07 carrier?
 
#6 ·
Got the Aussie swapped yesterday, took a couple of hours total.
Spent most of it getting the 3.07 carrier out of the diff, that sucker was stuck in there hard. Had to pull the spiders while the carrier was still in the diff to get some leverage.
Pulling the Aussie and reassembling it was stupid easy.

Broke my fawkin vise tho, that sucked :mad3:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top