UCTJ

That's the plan! I was actually thinking of snagging a Dana 70 or 14B and cutting off the ends, making a FF 9". That would be pretty badass.

Thinking about it. Too cheap to pass up. I'm working on getting the parts together for a 609 build and want that spool until I can get a 2nd 35 spline ARB. I found a guy about 4hrs away in SLC Utah who has some inner Cs for cheap. I still don't know what I'm gonna do for housings. I want to get some Ballistic units front and rear but we'll see how budget goes. Doing this ON THE CHEAP! :D

Awesome, thanks man.

Hey what Bronco forums were you talking about? Ebay has some of those big bearing cases but they're still $225.

Yeah over off of 3009, they still live there. I've seen your TJ. Every once in a while I'll see it when I'm on leave too. My old man just bought a F250, so if you see a bigass chip'd Ford blowing smoke around there, give him the bird and tell him it's thanks to his son! haha.

When I take leave again I'll have to hit you up, we can get a beer.

I bought the ARB!!! It needs new seals since his compressor was left on, but not bad. Under $300 shipped! Now I just gotta be on the lookout for a 3.25" bearing case for the 9 and I"ll be all set.

Nah, welder sold before I could get it. Yeah I lived in Schertz, its where I grew up. I worked on Randolph as a civilian but after I joined they sent me over here to Idaho. I actually bought my TJ up in Austin and drove it all the way here.

Looks like I'm 3rd in line but #1 guy can't pay. I offered to buy it right now, we'll see what he says :D

What do you think dude....I got a line on a 35 spline 9" ARB for about $250 in the B/S/T section. Should I get it? Money is kinda tight, but those ARBs are $850 new. I'd have to buy a new a case and bearings, but I got 35 spline shafts already.

I thought you had a 8.8 in the rear, why did you swap it?