 |
|
|
 |
04-15-2003, 07:41 PM
|
#1 (permalink) |
|
Registered User
Join Date: Jan 2001
Member # 2708
Location: Pilot Point Tx
Posts: 2,912
 |
Hardtop for 404's
 I just put a link to making a hardtop for 404's in the Tech sticky thats up above. The sticky thread is titled Important! Unimog 404 tech data including axle data ( 1 2 3 ) You'll find it on page three.
__________________
It's a Daimler thing: You wouldnt understand! [i]"I work on a fishing boat. I started as a Apprentice Baiter. Now I am a Journeyman baiter. One day I hope to make Master Baiter". (By DEnd)[/i] Last edited by coachgeo; 04-21-2003 at 05:25 AM. |
|
|
|
04-20-2003, 08:43 PM
|
#2 (permalink) |
|
Registered User
Join Date: Apr 2003
Member # 18905
Location: Santa Maria, CA
Posts: 1
  |
Hard Top, 404
The pictures you have of the hard top that was done in BC; do you have a way I can reach the owner of that truck? I need some information from him about the doors he had made.
Thanks Dave |
|
|
|
| Sponsored Links |
|
04-21-2003, 05:19 AM
|
#3 (permalink) | |
|
Registered User
Join Date: Jan 2001
Member # 2708
Location: Pilot Point Tx
Posts: 2,912
|
Re: Hard Top, 404
Quote:
The website I got this from is in the sticky as stated in the opening post in this thread. I edited the opening post to make this more clear. The sticky thread is titled Important! Unimog 404 tech data including axle data ( 1 2 3 ) You'll find it on page three. Thanks for stopping in... do so more often.
__________________
It's a Daimler thing: You wouldnt understand! [i]"I work on a fishing boat. I started as a Apprentice Baiter. Now I am a Journeyman baiter. One day I hope to make Master Baiter". (By DEnd)[/i] Last edited by coachgeo; 04-21-2003 at 05:31 AM. |
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
All times are GMT -7. The time now is 02:33 PM.