Montero trailing arm question.

[williambelk587]

Does anyone here know what thread is on the Montero rear trailing arm?

I think its 5/8" but I am not sure what wrap. Also if anyone can point me in the right direction to a female threaded rod end that will thread onto these arms it would be greatly appreciated.

Thanks,

Will

[sneakyninja]

Metric for sure, can't remember the size off hand though.

[rxinhed]

Did you break an arm? They are cast iron. May just want to get some newer Gen II arms.

[williambelk587]

I was trying to find a heim I could thread onto the bolt end to improve range of motion but I don't think anyone makes a female heim with that metric thread.

I did however answer my original question if anyone else needs to know the threads are 16x1.5 Metric. They are the same as the two bolts on the axle side and if you need the bolts they are 16x1.5x90mm.

Post up if you know anywhere that will sell a female rod end/Heim with custom internal threading or a blank female end that I can machine out to 16x1.5.

Thanks guys,

Will