Pirate 4x4 banner

MAX Metal thickness for dimple dies.....

7K views 2 replies 2 participants last post by  cornbinder 
#1 ·
I just ordered up some light racing dimple dies...they say they are for .125...All the dimple dies I have found are all for .125...Are there dies for thicker material or are people just taking the dies over the recommended thickness?...I found a pic of a crossmember, and it would seem that .125 is too thin for a crossmember skid plate...But in the pic, it looks like it is thicker than .125...Anyone have any input on dies and metal thickness uses?



Here is the thread this came from..
http://www.rme4x4.com/showthread.php?55548-Project-Toyota-Tacoma-Doublecab/page9&
 
See less See more
1
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top