Pirate 4x4 banner

Useing 3/4" Heims on a tie-rod question.

519 views 1 reply 2 participants last post by  enigma2y0u 
#1 ·
Im useing 3/4" Chromoly heims and 1.5" DOM tubing as by steering on my tj. My drag ling will be made of 3/4" heims with highmisalignment spacers and the tie-rod will be made of 3/4" heims with 5/8"s reducers. My question is if my bearings on my tie-rod heims start going out and giving me death wobble, would welding the bearing in place be a reasonable option? Or will welding on the chromoly take away some of the structual integrity?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top