Pirate 4x4 banner

I'm retarded with my driveshaft :P

696 views 3 replies 3 participants last post by  Foxx249 
#1 ·
U-joint shattered, was a BITCH to get out, got it out and replaced, and realized I didn't mark the grooves when I pulled the shaft before all of that.

Does it matter if I'm off a few grooves? Or am I fucked? :shaking:

Any way to figure this out? :p thanks!
 
#2 ·
Assuming "groves" = splines, yes it matters unless it has a double cardian cv joint at one end.

The yokes should be aligned, meaning the ears on each end of the shaft should be aligned with each other.
 
#4 ·
Just an update to those who care, the cap on my U-Joint exploded. When I put the driveshaft back together (i hadn't marked anything when i took it apart) it runs with no vibrations and i just guessed which tooth it went on lol. Runs great, no vibrations, nothing wrong. Maybe i got lucky?

Thanks for your help guys!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top