Pirate 4x4 banner

10 bolt front 6 to 5 lug conversion

571 views 5 replies 3 participants last post by  usmcdoc14 
#1 · (Edited)
ok i have searched this. and did not get to far. i figured i would through this out there

my problem is i have a front 10 bolt with the big bearing spindles and i need to put 5 on 5.5 lug rotors.

i have found a lot of info using the small bearing spindles but is there a rotor bear combo i could use to make the big bearing spindle work for what i want to do.
 
#3 · (Edited)
early/mid 80's dodge 3/4ton PART TIME (please note that as they also used funky dana 44's with full time shit) 4x4 rotors and spindles are big spindle 5 on 5.5. go looking in the junk yard.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top