Pirate 4x4 banner

Traction bar

321 views 0 replies 1 participant last post by  muddpuppy01 
#1 ·
I am wondering if my thought process is good. I am thinking about taking 1.73 * 1/8 dom to make a crossmember for traction bars. For the bars I thinking of using 1 1/2 or 1 1/4 ( whatever I can get my hands on at my job site scrap ) 1/8 wall. I am only going in mud so no rocks to beat against. Would this set up work for what I need. It is going to be going under a cj 5 with yj leaves SOA. I know I am going to have to get the cross member bent for clearence for my driveshaft travel.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top