Pirate 4x4 banner

Hypertherm 600 Problems

758 views 2 replies 3 participants last post by  John H 
#1 ·
So the plasma stopped working and the "loose" consumables light went on and wont go away...

Replaced consumables, cleaned, took gun apart etc... All looks perfect.
Light wont go away, plasma wont work.

Any ideas?

-Todd
 
#3 ·
1....The consumables may be installed wrong installed wrong(no offence but i've seen it several times)
2....The cup safety switch is bad(the little switch at the back of the torch head)
3....The leads are broken in the torch cable(this also happens alot at the base of the torch handle).
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top