Pirate 4x4 banner

Notching small angles. Any tips?

520 views 0 replies 1 participant last post by  BogusBlake 
#1 ·
I can't seem to get my small angle notches to come out to my satisfaction. By small angles, I mean between 0 and 30 degrees between tubes. My drill press notcher produces great notches between 45 and 90. Anyone have some tips to make the small angles mate easier? Thanks!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top