Pirate 4x4 banner

Dryer for Plasma?

945 views 8 replies 5 participants last post by  PAToyota 
#1 ·
I just got a new miller 625 for the shop and i need a dryer/filter for my compressor,any suggestions?
 
#3 ·
Same here.

Make sure you have enough pipe to cool the air before it goes to the drip dryer / large particle remover... then on your plasma cart put the motoguard. You don't want the motorguard right after the tank or within really 5ft of the line as it will get soaked FAST.
 
#4 ·
Build a liquid cooled Franzinator :flipoff2:


I'm building two of them right now to run parallel. Have an old chest freezer that goes to 0 degrees. Antifreeze/water in separate container in the freezer using a Parts Washer pump to distribute the liquid to the Franzies. Should work pretty well.

Probably too much work for just a plasma though.
 
#9 ·
Used the Motorgard filter setup but just didn't feel it was working in my situation - so just picked up a 25cfm Hankison air dryer. Have to get it installed and let you know how it works.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top