So, since the plasma will soon see some serious usage I decided to upgrade from my large particle separator and M60 filter to a 'drying system'.
My plan is as follows:
(In line of setup)
- A couple runs of pipe up and down w/drains @ bottom
- Large Particle Removal filter
- HF Electric powered air dryer
- Eaton Coalescing filter rated for up to 10hp (~35cfm max)
- M60 "TP" dryer/filter before plasma
Am I missing something, or is there anything you would add or change?
My thought was maybe adding a Desiccant Dryer (Cheap small one) after the M60 to get the last bit of h20... and to see if the previous drying methods WERE in fact working.
Opinions?
My plan is as follows:
(In line of setup)
- A couple runs of pipe up and down w/drains @ bottom
- Large Particle Removal filter
- HF Electric powered air dryer
- Eaton Coalescing filter rated for up to 10hp (~35cfm max)
- M60 "TP" dryer/filter before plasma
Am I missing something, or is there anything you would add or change?
My thought was maybe adding a Desiccant Dryer (Cheap small one) after the M60 to get the last bit of h20... and to see if the previous drying methods WERE in fact working.
Opinions?