Birf rebuild - Pirate4x4.Com : 4x4 and Off-Road Forum

utahsamiman · 01-09-2005, 05:02 PM

I am going to repack and change out all the seals and gaskets soon. Any tips? I did my bros fj40's a while ago. Anyone knows if they are similar. I would think so. I also want to drill in a ?zurk? into the outer housing to fill it up every so offen. Good/Bad?

samuraiman · 01-09-2005, 10:42 PM

Just remember be patient. This is time consuming and sometimes frustrating. Although not too big of a deal. Of course have the parts bucket ready and some good rags. Better yet get rid of em j/k I am still running em with the toyota axles.. As far a a zerk that is up to you never heard of anyone doing it though. just pull the cap off on the top and the grease gun fits right in there.

01-09-2005, 05:02 PM	#1 (permalink)
utahsamiman Registered User Join Date: Dec 2004 Member # 39966 Location: Lehi, Utah Posts: 190	Birf rebuild I am going to repack and change out all the seals and gaskets soon. Any tips? I did my bros fj40's a while ago. Anyone knows if they are similar. I would think so. I also want to drill in a ?zurk? into the outer housing to fill it up every so offen. Good/Bad?

01-09-2005, 10:42 PM	#2 (permalink)
samuraiman Registered User Join Date: Jan 2005 Member # 41294 Location: UTAH Posts: 68	Time Just remember be patient. This is time consuming and sometimes frustrating. Although not too big of a deal. Of course have the parts bucket ready and some good rags. Better yet get rid of em j/k I am still running em with the toyota axles.. As far a a zerk that is up to you never heard of anyone doing it though. just pull the cap off on the top and the grease gun fits right in there. Last edited by samuraiman; 01-09-2005 at 10:43 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode