question for those with toyota cv in front driveline - Pirate4x4.Com : 4x4 and Off-Road Forum

Brad Juan · 06-11-2005, 05:09 PM

I am needing to put a toyota cv in my front driveline. Does the CV clear the trans. crossmember? If you have had to cut it, what are you using to reinforce it? Thanks for your time.

SPINY · 06-11-2005, 05:43 PM

I'm running a cv front and cut out the crossmember and use Rockrats tranny mount

budgetsami · 06-11-2005, 06:50 PM

ditto---use rockrats trans mount and cut the stock crossmember out---you'll have gobs o room to work with

Brad Juan · 06-12-2005, 08:59 AM

what is your opinion of re-drilling the t case flange out for the toyota pattern?

Rockrat · 06-12-2005, 11:39 AM

Quote:

Originally Posted by Brad Juan

what is your opinion of re-drilling the t case flange out for the toyota pattern?

If it is a CV it wont work the pattern is to large for the small flange, and if it is the big flange I wouldnt trust the amount of meat left to hold. BTW you also have to have the centering ring of the flange machined to except the shaft. right there is enough to justify adapters. Alos the CV will not work in front (will not clear the stock x-member) You could also use a non cv rear toy shaft shortened for your front.

06-11-2005, 05:09 PM	#1 (permalink)
Brad Juan Registered User Join Date: Jul 2003 Member # 21557 Location: Chico CA Posts: 600	question for those with toyota cv in front driveline I am needing to put a toyota cv in my front driveline. Does the CV clear the trans. crossmember? If you have had to cut it, what are you using to reinforce it? Thanks for your time.

06-11-2005, 05:43 PM	#2 (permalink)
SPINY Granite Guru Join Date: Jun 2003 Member # 20580 Location: Clinton,IN Posts: 805	I'm running a cv front and cut out the crossmember and use Rockrats tranny mount __________________ www.branikmotorsports.com #518 Brandon Haynes

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

06-11-2005, 06:50 PM	#3 (permalink)
budgetsami Registered User Join Date: Feb 2005 Member # 43278 Location: Ceres, Ca Posts: 222	ditto---use rockrats trans mount and cut the stock crossmember out---you'll have gobs o room to work with

06-12-2005, 08:59 AM	#4 (permalink)
Brad Juan Registered User Join Date: Jul 2003 Member # 21557 Location: Chico CA Posts: 600	what is your opinion of re-drilling the t case flange out for the toyota pattern?