ProTools HPM 200 tube bender - Pirate4x4.Com : 4x4 and Off-Road Forum

mmmkay325 · 10-12-2008, 06:57 AM

Modeled after the ProTools HPM 200 tube bender. Air over Hydro jack. Comes with 3/4" die -$200. Located near Charlotte, NC

fabcam · 10-12-2008, 07:32 AM

I don't see the other half of the die in your pic. Do you have it?
Like shown here:

mmmkay325 · 10-12-2008, 10:07 AM

yeah, the follower....i have it. It just didn't make it into the pic.

10-12-2008, 06:57 AM	#1 (permalink)
mmmkay325 Registered User Join Date: Mar 2004 Member # 28854 Location: NC Posts: 139	ProTools HPM 200 tube bender Modeled after the ProTools HPM 200 tube bender. Air over Hydro jack. Comes with 3/4" die -$200. Located near Charlotte, NC __________________ 88YJ hp60/14b 39.5Irok 102wb

10-12-2008, 07:32 AM	#2 (permalink)
fabcam Rock God Join Date: May 2003 Member # 19763 Location: MN Posts: 1,546	I don't see the other half of the die in your pic. Do you have it? Like shown here: __________________ The site for the fabricator: www.offroadfabnet.com Bend-Tech PRO is now available!!! Design full tube chassis in less than a couple of hours with the PRO We are the developers of the Bend-Tech products. 651-257-8715 for sales and support www.bend-tech.com 10,000+ now using Bend-Tech

10-12-2008, 10:07 AM	#3 (permalink)
mmmkay325 Registered User Join Date: Mar 2004 Member # 28854 Location: NC Posts: 139	yeah, the follower....i have it. It just didn't make it into the pic. __________________ 88YJ hp60/14b 39.5Irok 102wb

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode