Pirate 4x4 banner

Dimple Dies -- New Lower Price!

231K views 1K replies 482 participants last post by  twoslo4five0 
#1 ·

dimple dies made from bearing steel, super hard and long lasting stuff.
these are a good quality, nice looking and affordable set of dies. these will dimple 3/16", but i don't recommend dimpling over 11 guage if you want a good looking flare. THESE WILL WORK BETTER AND LAST LONGER IF YOU LUBE THEM WITH YOUR CHOICE OF LUBRICANT. GREASE, WD-40, etc.

these dies are for flaring a hole, and are not to be used for punching a hole. you will need hole saws or your own preferred method of making holes.

these are always in stock unless noted in this thread.

small set (1/2", 3/4", 1") $60

medium set (1-1/4", 1-1/2", 1-3/4") $120

large set (2", 2-1/2", 3") $190

6 pc set (small and medium) $175

6 pc set (large and medium) $285

10 pc set (all sizes plus dzus die) $345

small 3 pc set ships for $6, all other sets ship for $15

i get requests all the time for individual dies or random different sizes, and i would have to sell them at a higher cost per die. i wont sell anything other than sets listed above for 2 reasons- you would end up paying more than i'd like to charge, and i end up with random dies that sit on the shelf forever. thanks for understanding.

pics are gone for some reason, so click here to see- http://www.pirate4x4.com/forum/tool...ple-dies-new-lower-price-35.html#post14952449
 
See less See more
#749 ·
IIRC it's $50, full set is about a million unless i ship 2 boxes.:laughing:
downside of the cheap USPS shipping is the insurance wont cover the full amount, but close enough to make it worth your slight risk.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top