 |
|
|
 |
07-21-2010, 07:08 PM
|
#1 (permalink) |
|
Wheeler
Join Date: Jan 2008
Member # 107105
Location: RENO NV
Posts: 250
|
tm3 question
i don't know it this matters but when my stuff was first set up. a blue line would be tracing the part it was cutting on my screen. and now its a bunch of dots tracing the pattern it's cutting.
__________________
/forum/toyota-truck-4runner/760359-cummins-powered-4-door-4runner.html |
|
|
|
07-21-2010, 08:09 PM
|
#2 (permalink) |
|
Rock God
Join Date: Aug 2007
Member # 98865
Location: Reno, NV
Posts: 2,258
|
Sounds like the refresh rate for the screen in the TM Driver Software has been turned down. I don't know where to tell you to change it back at the moment. One of the tech guys can tomorrow I am sure. If your computer is not the fastest, then sometimes we will go in and change the refresh rate so that it can use more resources to run the program rather than update the viewer.
__________________
WWW.TORCHMATE.COM We are hiring! Email your resume to our Human Resources Manager at cnichols@torchmate.com and ask about openings. Buy your consumables here! www.torchmatestore.com Torchmate Racing Homepage: www.torchmateracing.com Torchmate CNC Forum here: /forum/125-torchmate-cnc-forum/ |
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
All times are GMT -7. The time now is 11:40 PM.
