#89 build starts

[MT4Runner]

That's not far away from living and breathing!!!

[DirtWorshiper]

I love this build. Any updates?

[1sicbronconut]

A few updates and I'll get some pic's up during the week. My wife and I have been wanting to move back up to tha Black Hills of South Dakota (lived there in the 90's) my wife found a good job up there and has been in Rapid City working for the past two weeks so I guess I'm moving also We talked about moving a few years ago and I've had a open offer at the local Ford deaership since that time, so I've been busy getting the house ready to sell for the past few weeks. I've already made a few trips up there with all my projects but the F-Bronco is still in the garage so I can get some time in on it, going to take me four trips just to haul the projects up there Not looking forward to moving my tool box from work, it weighs about 3-4,000 pounds loaded.

[1sicbronconut]

Got the new shop half way set up and I've been getting back to work on the project.

[a2b]

where did you get the hood?

[sabas]

Looks like an early bronco hood.

Sabas

[1sicbronconut]

Yup it was a old very cheap single layer non reinforced Bronco hood that I cut up.

[cheapthrillb2]

I have been seriously wondering what my next move might be with my eb since my body has seriously turned to hell. I think you have inspired me.

[1sicbronconut]

Been woking away on #89 had it pretty much all together last month and have torn most of it back apart to paint it Need to get a heater for the shop so I can finish it up. Rode along with a friend in his buggy during the Dakota challenge that helped me get fired up to get the thing finished up. I was in the bitch seat in this picture, rolled my own junk but I've never been a passenger in one The other pic is some of the nice backdrop you get on some of the South Dakota trails!

[DirtWorshiper]

Bitchen, nice work, thanks for the updates!

[robn69]

Love this thing!! Keep the updates coming! Nice work!

[1sicbronconut]

Put the wheels on and pushed the beast out so I could clean the shop out before winter hits.

[bf]

any more progress on this thing? sweet project!

[toyoturd]

is it the angle but looks like the axle is pushed far to pass side easy trac bar adjustment or has to be that way?

[1sicbronconut]

Might be off a little but I think it's more the camera angle, I do have a adj track bar though. Coming along plumbing is done finishing up the wiring Lame excuse but I've been taking my time I tend to get my junk good enough to wheel and never really get them finished I want this one done right.