Pirate 4x4 banner

power steering bracket help

700 views 2 replies 3 participants last post by  4N JEEP 
#1 ·
Hey guys need help im looking for a power steering braket that fits tighter to the block or up a litter higher, I have GM 350 with a short water pump the problem is my steering shaft is to close to the pump pulley ,, i have a saginaw steering set up with gm tilt wheel resevior type saginaw pump V belt ,, just an inch would do it either way ,, I was looking at this one from jegs but can not find a pic installed http://www.jegs.com/i/JEGS+Performance+Products/555/60702/10002/-1

I have tried a few brackets, i have the stock one right now, just trying not to have to buy anymore

any help would be greatly appreciated im sure someone has ran into this problem before
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top