![]() |
![]() |
|
|||||||
| Register | Blogs | FAQ | Members List | Social Groups | Calendar | Mark Forums Read | Premium Memberships | Auto Loans |
![]() |
|
|
Share |
| Thread Tools | Display Modes |
|
|
#1 (permalink) |
|
Registered User
Join Date: Aug 2007
Member # 97505
Location: fresno
Posts: 26
|
power steering bracket help
Hey guys need help im looking for a power steering braket that fits tighter to the block or up a litter higher, I have GM 350 with a short water pump the problem is my steering shaft is to close to the pump pulley ,, i have a saginaw steering set up with gm tilt wheel resevior type saginaw pump V belt ,, just an inch would do it either way ,, I was looking at this one from jegs but can not find a pic installed http://www.jegs.com/i/JEGS+Performan...60702/10002/-1
I have tried a few brackets, i have the stock one right now, just trying not to have to buy anymore any help would be greatly appreciated im sure someone has ran into this problem before |
|
|
|
|
|
#3 (permalink) |
|
Wheeler
Join Date: May 2001
Member # 4620
Location: Sausalito CA
Posts: 306
|
check out the one PSC sells, I have the one for a long water pump.
http://www.pscmotorsports.com/motors...l-sbc-swp.html Last edited by 4N JEEP; 04-30-2012 at 02:13 PM. |
|
|
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|