Favor: Quick Measurement - Pirate4x4.Com : 4x4 and Off-Road Forum

ckolloff · 02-04-2003, 09:27 AM

Building quarters:

Somebody with a stock or even close to stock body. I need the height of the rear corner panel from the bottom of the sheet metal to the start of the recess for the hard top. Could you take the measurement at two places: 1-at the rear bumper just before the start of the radius, and 2- just after that radius on the flat bofore the wheel well.

Thanks

FIXXXXAH · 02-04-2003, 02:18 PM

IF NO ONE'S GOT YA BY THE TIME I GET HOME IN A FEW HOURS I'LL MEASURE FOR YA. YOU WANT FROM THE SECTION ABOVE THE REAR BUMPER TO THE START OF THE LIP FOR THE HARD TOP, AND FROM THE SECTION BEHIND THE WHEEL WELL AND BEFORE THE CURVE STARTS, RIGHT?

ckolloff · 02-04-2003, 07:08 PM

Thanks Fixxxah, I measured several at our local TLCA chapter meeting, I hadn't planned on going but not a bad thing to "have to" do.

02-04-2003, 09:27 AM	#1 (permalink)
ckolloff Registered User Join Date: Nov 2001 Member # 8459 Location: NahFock VA Posts: 764	Favor: Quick Measurement Building quarters: Somebody with a stock or even close to stock body. I need the height of the rear corner panel from the bottom of the sheet metal to the start of the recess for the hard top. Could you take the measurement at two places: 1-at the rear bumper just before the start of the radius, and 2- just after that radius on the flat bofore the wheel well. Thanks __________________ Never ending Frankenstein FJ40 project.

02-04-2003, 02:18 PM	#2 (permalink)
FIXXXXAH Registered User Join Date: Feb 2001 Member # 3259 Location: NORTHERN NM Posts: 1,258	IF NO ONE'S GOT YA BY THE TIME I GET HOME IN A FEW HOURS I'LL MEASURE FOR YA. YOU WANT FROM THE SECTION ABOVE THE REAR BUMPER TO THE START OF THE LIP FOR THE HARD TOP, AND FROM THE SECTION BEHIND THE WHEEL WELL AND BEFORE THE CURVE STARTS, RIGHT? __________________ [SIZE=1] "ANYONE WILLING TO TRADE FREEDOM FOR SECURITY DESERVES NEITHER." TUBING AND BUGGIES ARE OVERRATED METRIC ROCKS. [/SIZE]

02-04-2003, 07:08 PM	#3 (permalink)
ckolloff Registered User Join Date: Nov 2001 Member # 8459 Location: NahFock VA Posts: 764	Thanks Fixxxah, I measured several at our local TLCA chapter meeting, I hadn't planned on going but not a bad thing to "have to" do. __________________ Never ending Frankenstein FJ40 project.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode