pinion degree shims?? - Pirate4x4.Com : 4x4 and Off-Road Forum

overeasy · 08-14-2001, 12:12 AM

Where do I find some? Some came on my truck and I broke one tring to take off that pack and put on my new pack. I think they are 4 degree. Any one know.
Thanks
Steve

justmyluck · 08-14-2001, 12:28 AM

Roger browns shims

Try this! i'm going to look into these myself.
Tom

OOP'S · 08-14-2001, 05:34 AM

Use STEEL shims and weld them into place. I think Roger's are milled steel. The aluminum ones are junk!!!! Also make sure that your center spring pin/bolt reaches all the way into the spring perch, not just the shim.

08-14-2001, 12:12 AM	#1 (permalink)
overeasy Registered User Join Date: May 2000 Member # 963 Location: Maricopa AZ Posts: 682	pinion degree shims?? Where do I find some? Some came on my truck and I broke one tring to take off that pack and put on my new pack. I think they are 4 degree. Any one know. Thanks Steve __________________ Toyota parts and duct tape on 39" reds

08-14-2001, 12:28 AM	#2 (permalink)
justmyluck Registered User Join Date: Feb 2001 Member # 3254 Location: Northeastern Pa. Posts: 445	Roger browns shims Try this! i'm going to look into these myself. Tom __________________ 91' Toy lifted&locked ARB front/Detroit out back w/5:29s, Allpro SAS,Hysteer w/Hyd. assist, square front shaft,next project dual cases.

08-14-2001, 05:34 AM	#3 (permalink)
OOP'S Wicked Raciest ! Join Date: Feb 2000 Member # 30 Location: Roseville, CA,To many Yuppies, Not enough Hippies Posts: 17,109	Use STEEL shims and weld them into place. I think Roger's are milled steel. The aluminum ones are junk!!!! Also make sure that your center spring pin/bolt reaches all the way into the spring perch, not just the shim. __________________ David & Theresa, Roseville, CA, Remember: Amateurs ... Built the ark. Professionals ... Built the Titanic http://www.davezoffroadperformance.com/ http://www.marlincrawler.com/ http://www.12voltguy.com/

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode