I'm getting the 30 spline longs. I'm planning on replacing the seals in the knuckle but don't know whether or not to replace the bearings and the inner axle seal. I haven't pulled it apart yet but would you replace the bearings or not? Thanks
Kane Smith jkanesmith@hotmail.com
i would just rebuild the whole thing while u have it apart since hopefully u wont be needing to tear it apart much at all any more
just do it all now will save u time in the long run
The 30 spline set comes with inner axle seals. Furthermore, I would just get the rebuild kit from Marlin, Its like $85, just do it once, because with the 30 spliners, its gonna be a long while before you have to open up the front end again!
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Pirate 4x4
18.7M posts
366.4K members
Since 2000
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!