I needed some high air flow doors on the truck.
I wanted the doors to fallow the seat line.
spent about 2 hours welding a 12ga 1''x1'' square tube in each door.
More of the doors done. In sides all braced up, and arm rest made.
I locked the lock open.
Todays task was to figure out the mounting for the latch.
I set the handle about a 1/4 inch in so the little plastic cover sits flush after the back sheet metal is on.
Front sheet metal.
More to come.
I wanted the doors to fallow the seat line.
spent about 2 hours welding a 12ga 1''x1'' square tube in each door.
More of the doors done. In sides all braced up, and arm rest made.
I locked the lock open.
Todays task was to figure out the mounting for the latch.
I set the handle about a 1/4 inch in so the little plastic cover sits flush after the back sheet metal is on.
Front sheet metal.
More to come.