Pirate 4x4 banner

Tricks for realigning Heim suspension bolts?

1K views 6 replies 7 participants last post by  mudtruck44 
#1 ·
All, I'm looking for tricks that allow re-aligning the upper suspension Heims and bolts after changing new hardware! Without pulling shocks and coilovers! I've tried several ratchet strap angles in order to rock the pinion back on rear and it still won't move it enough. Thanks in advance! I know I'm trying to shortcut!
 
#5 ·
I'm assuming your suspension is unloaded (drooped out)? This should allow you to either just push or tap parts into alignment.

I have also used a larger diameter screwdriver shaft to lightly pry the joint in/out/up/down once it's pretty close to where you need it to be.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top