Pirate 4x4 banner

1978 d44 set up why should I not do it this way?

463 views 1 reply 2 participants last post by  Skerb 
#1 ·
Project Jonco continues... I have a couple ways to do this install and I am leaning in this direction. Am I missing a good reason to not do this?
 
#2 ·
With this setup you have to buy different bushings for the radius arms to adjust pinion angle. As the bushings wear out you get axle wrap which induces wheel hop. Radius arms inherently get wheel hop when on inclines.

Why not just do a 3 link? If you have an axle with cast wedges already I would say go with it, but if they are welded wedges just cut them off and do a link setup.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top