Pirate4x4.Com : 4x4 and Off-Road Forum

Pirate4x4.Com : 4x4 and Off-Road Forum (/forum/)
-   General 4x4 Discussion (https://www.pirate4x4.com/forum/16-general-4x4-discussion/)
-   -   LQ4 LS throttle body questions (https://www.pirate4x4.com/forum/general-4x4-discussion/1450001-lq4-ls-throttle-body-questions.html)

Landslide 09-14-2013 10:46 AM

LQ4 LS throttle body questions
 
1 Attachment(s)
Working on wiring and plumbing on my engine and have a few questions about where some things go and if they are needed.

First is an electric sensor or solenoid in the top of the intake manifold right behind the throttle body. Has an electric plug to it and a hose off of it I'm not sure where it goes or what it's for?!?

Landslide 09-14-2013 10:47 AM

I should add its a 2002 year and drive by cable.

Landslide 09-14-2013 10:50 AM

1 Attachment(s)
Next are two hoses off of the throttle body, actually three but I think the lower left one is steam port from water pump. The two I'm wondering about is the top one on side of TB and long lower hose as well?!?

johny5.0 09-14-2013 10:50 AM

I'm not sure but I used one of them rubber frost plug things you tighten and they expand to block the hole

Landslide 09-14-2013 10:51 AM

1 Attachment(s)
.

Bo185 09-14-2013 11:23 AM

First picture is the EVAP canister purge valve remove it and plug the hole its not need unless you need to pass emissions.

Second picture is your fresh air inlet for the PCV system should go to the pass side valve cover. You need this.

Third picture is the TB heater lines remove them and run the steam lines from the drivers head in to the top of radiator.

Landslide 09-14-2013 11:27 AM

Quote:

Originally Posted by Bo185 (Post 20942585)
First picture is the EVAP canister purge valve remove it and plug the hole its not need unless you need to pass emissions.

Second picture is your fresh air inlet for the PCV system should go to the pass side valve cover. You need this.

Third picture is the TB heater lines remove them and run the steam lines from the drivers head in to the top of radiator.

Thank you.

Landslide 09-14-2013 11:28 AM

Quote:

Originally Posted by Bo185 (Post 20942585)
First picture is the EVAP canister purge valve remove it and plug the hole its not need unless you need to pass emissions.

Second picture is your fresh air inlet for the PCV system should go to the pass side valve cover. You need this.

Third picture is the TB heater lines remove them and run the steam lines from the drivers head in to the top of radiator.

Thank you.

I have a spacer kit on my f body water pump which has a steam port in it.


All times are GMT -7. The time now is 06:05 PM.

Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 ©2011, Crawlability, Inc.
User Alert System provided by Advanced User Tagging (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.