Pirate 4x4 banner

420 into a wrangler slave cylinder questions

597 views 2 replies 3 participants last post by  KAcrawler 
#1 ·
I have a 1961 sm 420, a ranger over drive, and a 95 TBI 350 going into my wrangler. The bellhousing is also a 61 and is cast iron which I am told is the strongest setup. The question I have is will my master clutch cylinder push the chevy slave cylinder well or will I have to swith out to chevy model or something else? Let me know. thanx.


P.S. Granny four speeds are the shiiaaaat :smokin: automatics are :rainbow: and they :nuke:
 
#3 ·
i think you should go home and cry :crybaby2: because your jeep will never run again. you are going to have to push it back to alaska.

AH THE JOYS OF A MOTOR SWAP!!!!!!!!!!!!!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top