I am going to cut my link tabs this week, but have yet to decide on which joints to run. I would like to know some of the outside diameters of the JJ and RE joints or anything you think might be better. Second, how much over this dia. would you make the tabs(to avoid direct hits).
I am going to cut my link tabs this week, but have yet to decide on which joints to run. I would like to know some of the outside diameters of the JJ and RE joints or anything you think might be better. Second, how much over this dia. would you make the tabs(to avoid direct hits).
Thanks
I will go a little over on the diameter to protect the joint. Do you have any suggestions with regards to any design aspects. I assume 1/4 HRS is fine.
1/4" to 1/2" D is pretty standard for joints around here.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Pirate 4x4
18.7M posts
366.7K members
Since 2000
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!