3 link versus 4 link
Has anyone ran spherical bearing cup on the top of the axle instead of a heim
joint for a 3 link? Kinda like a control arm on an IFS, I think it would handle side
loads better than a single heim joint. And no trackbar .I see a lot race truck use them for control
P.S. I was think of using it only on the rear
Cheaper, lighter, and stronger then using a rod end. There is no downside as long as you don't warp the cup when you weld it.
i run a r.e. large builder ball
|All times are GMT -7. The time now is 09:07 PM.|
Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 ©2011, Crawlability, Inc.
User Alert System provided by Advanced User Tagging (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.