|01-15-2020 09:42 PM|
Sent from my SM-G973U using Tapatalk
|01-13-2020 06:01 AM|
|01-12-2020 08:53 PM|
Top is double cardan joint (common yota), bottom is non-cv
|01-12-2020 05:55 PM|
Rear drive shaft angle question
What's up. So I've been sitting on this Samurai for a while. I'm taking out the rear shaft to either remake or balance the one I have. My question is in regards to the angle of the drive shaft. Right now the bottom flange is pointed probably 1 to 2 degrees downwards.
Should the rear diff point directly at the tcase, level to the ground or down a couple degrees towards the earth? I'd post images but I'm under 10 posts. Thanks.