|09-16-2010 10:19 PM|
|09-16-2010 08:57 AM|
Grab a Kevco, throw a skid under it mounted to the chassis and be done with it.
Just check to make sure the seal surface on the pan is perfectly flat before you mount it.
|09-16-2010 08:47 AM|
|HardcorewannabeXJ||x3 on changing to to an f-body car pan. You'll need to modify the pickup a little bit, and cut some "slots" to allow the oil to move to the rear of the pan easier for climbs (which adversely effects going down steep things as well, but where would you want the oil pressure?) Or you could buy a Kevko.|
|09-15-2010 09:14 PM|
LOL... I would break that thing in my driveway. Kevko will make building a chassis mounted skid a bunch easier. Fit and finish is .......ok? Wish somebody would make a good quality unit.
|09-15-2010 08:27 PM|
The picture of the whole in his pan looks like a truck pan which are about 8" deep. So a 5" kevko pan would be a good option but you could also go with an ls2 pan or f-body pan if you don't want to go to an external oil filter.
search around on here before making a switch though. the car oil pans have the pickup much farther forward and you really need to use an accumulator with them and if you have the f-body pan an Improved Racing baffle potentially as well. Quite a few people have kevko pans and they work as advertised but the fit and finish is pretty bad and you may have problems getting it to seal along the back edge. Dave Cole says he had a similar problem with his Kevko pan.
My Kevko pan dented even with a skid underneath it so there's no way an engine mounted skid will hold up to how we race.
|09-15-2010 07:46 PM|
|09-15-2010 07:39 PM|
|TCARP1||Eric get a Kevco pan, they are steel and a little shallower than the aluminum ones.|
|09-15-2010 07:36 PM|
|chris demartini||What pan are you using?|
|09-15-2010 07:34 PM|
Good call Tom.
New engine for this car and the pan sits a bit lower than the subframe making it a little tricky to add one.
|09-15-2010 07:28 PM|
|Gunmetalcruz||engine skid needs to be attached to the chassis not the motor IMO otherwise all you will be doing in the future is changing broken auto trans cases when you hit the motor and the trans doesn't move.|
|09-15-2010 07:27 PM|
|chris demartini||Never seen such an item. The cast pans are fragile. It would probably be a better idea to build it into your chassis.|
|09-15-2010 07:21 PM|
6.0 Skidplate Needed
Does anyone make a bolt on skidplate to cover the cast oil pan on a 6.0? I noticed there's a few good size threaded holes at the bottom of the block I figured could be used for mounting.