|02-12-2020 04:19 PM|
|02-10-2020 03:06 PM|
|11-16-2019 09:39 PM|
|CSpeade51||old thread but Va Beach here|
|05-06-2019 04:45 PM|
|K9Kodi||Anyone doing anything next week. Working on the square body!|
|04-10-2019 12:51 PM|
|K9Kodi||I’m in Richmond now though, 3 days a week and home 4 days a week|
|04-10-2019 08:18 AM|
|Benzz0||Paging APRILRAZZ and usmcdoc14, you're needed in aisle 3|
|04-09-2019 09:30 PM|
|K9Kodi||If this place is still up I’m here. Live on the Norfolk va beach line in the diamond springs corridor. Currently working or finishing a square body resto. Drive a 2015 ram diesel g56. All I do is work my dogs, work on my truck, do projects and hunt/fish.|
|12-25-2018 11:22 PM|
Also, not trying to hijack the thread but also dont want to start a new one for a simple question. Yall know anyone that can weld up beadlock rings to steel wheels?
|03-11-2018 07:18 AM|
I've got a 1978 F150 Regular Cab Shortbed - 4x4, 351M, C6. Previous owner cobbled together some leaf-spring packs and threw some coils in to give it a small lift with 31's. Open diffs.
I live right on the edge of downtown and have already heard about a few break-ins.. not too thrilled about that.
Got it to pass state inspection and have been driving it a bit but need to rent some space at Rent-a-lift and do a tune-up, install new Warn hubs, and replace the rear yoke. After that, lift, 35's, and probably a mini-spool.
|03-03-2018 06:17 AM|
Be careful in Norfolk, locals tend to like to take anything thats not chained down.
|03-02-2018 11:07 PM|
There are a few of us who live Kinda close to Norfolk that are big into wheeling
What you got to wheel
|01-27-2018 12:39 PM|
|01-11-2018 04:32 AM|
I’m near the Norfolk airport. I am constantly working in my garage. Currently trying to undress some SD axles. That plasma cutter sure would be nice!
Sent from my iPhone using Tapatalk
|12-04-2017 09:27 AM|
|amgraham||I'm in Richmond. I know there's quite a few members in the tidewater area.|
|12-03-2017 06:40 AM|
|92vegasYJ||Im here. I live in Portsmouth. I used to live in SD as well.|
|12-01-2017 09:05 AM|
Just moved here from San Diego, CA. In an apartment downtown and not allowed to wrench in the parking lot. Have a mig welder (Millermatic 210), plasma cutter, and IR air compressor all sitting in storage and no where to use them Just wondering who else is around.