|10-21-2019 07:09 PM|
Basic description of rig: 2000 GV 4 door
Engine: 2.5 v6
Transmission: 4 speed auto
Transfer case(s): 4.24:1
tire size: 33ís
Type of wheelin you do: rock crawling, dd, long distance highway, lots of desert running
How you like it on the highway: itís ok, needs more rpm in 4th, 2600 doesnít cut it even with exhaust, intake, high timing, and cams advanced 4*.
How you like it offroad: awesome till you hit sand. High range is too high, low is too low. Stock low range is perfect
If you had to do it again whats gears would you buy: 5.71 would be better suited, first gen 4 speed with the lower 4th gear and a tracker/tracker doubler would be tits
|10-21-2019 11:57 AM|
Basic description of rig: 4 door 99 track kick 2" spacers f&r
Transmission: 3spd auto
Transfer case(s): 4.16 sami
tire size: 32x10
Type of wheelin you do: little bit of everything, snow, rock crawling, dirt roads and trails, ect
How you like it on the highway: far from a highway rig. Top speed with no OD and Sami case. Around town and mountain roads it works well.
How you like it offroad: 4:1 is what they should have had stock. In actual rock crawling, it's not enough. What's nice is that high range is usable off road.
If you had to do it again whats gears would you buy: 6.4s or a doubler would be good.
|02-14-2019 03:51 PM|
Basic description of rig: 1972 Jeep CJ5
Engine: 2.3L Suzuki Aerio
Transmission: Samurai 5 speed
Transfer case(s): Samurai 6.5:1
tire size: 34" swampers to 37" MTR's
Type of wheelin you do: PNW trails, snow
How you like it on the highway: too low geared, 55 mph is comfortable
How you like it offroad: good, but could be better
If you had to do it again whats gears would you buy: i'd do a vitara/tracker hydraulic 5 speed w/ tracker/vitara rangebox and 4.7 geared toyota case doubler - a gear for every scenario. I was either too low or too high w/ single sami case
|02-11-2019 02:07 PM|
|Gwagensteve||4.88 R&P would correct the speedo with 33Ē tires. Can you give me an RPM at a GPS confirmed speed in 4th or 5th gear?|
|02-11-2019 05:53 AM|
|02-09-2019 10:40 PM|
You do realise it's mechanically impossible for transfer gears to change the speedo reading, right? As I said, if changing transfer gears changed the speedo reading, then so would every gear change in the manual transmission.
Don't just assert what you saw on your vehicle, You haven't proved anything. Prove me wrong mechanically. The speedo drive is pressed onto the output shaft of the transfer and so is locked to tailshaft speed. Just think about that carefully when scripting your response.
|02-09-2019 10:22 PM|
Basic description of rig: Some tube tube and rust
Engine: 1.6 8v with 1.3 EFI, header 2" exhaust
Transmission: 1.6 tracker 5 speed
Transfer case(s): kicker 3 ( side kick doubler (stock gears) to samurai 5.14
R&P: toy 4:30
tire size: 39.5
Type of wheelin you do: rock and new england muck
How you like it on the highway: not in years trail rig
How you like it offroad: works good
If you had to do it again whats gears would you buy: will bee adding auto soon
|02-09-2019 10:16 PM|
|02-09-2019 10:04 PM|
|supazuk94||great topic adding to FAQ|
|02-08-2019 03:05 PM|
You're missing that the speedo drive can't see what's happen upstream of it, only downstream. For your example to be correct, the speedo would read differently in each gear.
The speedo is calibrated for rear end ratio and tire diameter. If you put reduction gears in the transfer case, the engine revs to achieve the same transfer output speed increase. If the car was running stock tyres and axle ratio, the speedo would still read correctly, the engine just has to rev higher to make the output shaft of the transfer spin at the same speed it did before.
If I change gear from 5th to 4th, revs jump up at the same output shaft speed, just like fitting transfer reduction gears, the speedo has no idea this has happened either.
So say now I put 31" tires on. These are bigger so for the same transfer output speed, the car travels 16% faster. The speed reads 50 MPH but the car is doing 58mph. I can gear the transfer case however I like, or put the car in whatever gear, when the speedo is reading 50MPH, the car is still actually going 58.
Transfer gears correct gearing with bigger tires - they do this by increasing engine speed at a given road speed, but the speedo can't see this. The speedo still thinks the car has 26" tires on it and a 3.7 rear end. Changing the axle ratio will effect the speedo reading, as will changing tyre size. They're the only two things that can change it.
|02-08-2019 01:36 PM|
|02-06-2019 11:50 PM|
The speedo drive is on the output of the transfer case that means itís unaffected by anything upstream of the speedo drive- what gear the gearbox is in, what range the transfer is in, or transfer case reduction.
Itís only affected by whatís downstream of the speedo drive- axle ratio and tyre size.
Put bigger tyres on and the speedo becomes inaccurate. Change the axle ratio and speedo becomes inaccurate. Put the transfer case in low range and the speedo doesnít become inaccurate.
I canít explain it any more clearly.
|02-06-2019 08:32 AM|
|02-04-2019 04:05 PM|
|Gwagensteve||The speedometer doesnít know what gear you are in. Just the same way the speedo doesnít change its reading when you change gears in the gearbox or change ranges in the transfer case, it doesnít know that there are reduction gears in the transfer case. It took me a while to work this out myself. Yes, it corrects revs at road speed, but NOT the speedometer, because itís downstream of the reduction.|
|02-04-2019 06:00 AM|
|02-03-2019 10:57 PM|
|02-03-2019 08:14 PM|
|02-02-2019 07:39 PM|
|Gwagensteve||That doesn't make any sense - transfer case gears have no effect on the speedometer accuracy, that's a function of axle gears and tire diameter.|
|02-01-2019 08:59 AM|
Basic description of rig: Stock '87 Samurai with SPOA and TC Gears
Transfer case(s): 5.14:1 Calmini
tire size: 33x10.50
Type of wheelin you do: trails, rocks
How you like it on the highway: In high range, speedo is almost right on
How you like it offroad: low range is low.
If you had to do it again whats gears would you buy: Only con I have with these TC gears is that they are noisy. They whine. It's a common issue with Calmini at least it was 15 years ago when I got them.
|02-01-2019 05:24 AM|
Basic description of rig: Stockish Samurai on YJ's springs SPUA
Engine: 1.6 16v
Transmission: Stock Samurai 5 spd
Transfer case(s): 6.5:1
R&P: Stock 3.73
tire size: 34" LTB's
Type of wheelin you do: Typical east coast trails
How you like it on the highway: Great
How you like it offroad: Great
If you had to do it again whats gears would you buy: Same 6.5:1
|01-25-2019 10:19 PM|
I don't see the 3.0 gears being worth the money, just not enough of a jump. I think the Sami case with 4.16 or 4.9s would be sweet. I don't need to go more the 45 mph, so 1.6 high with 4.63s or 5.13s and 31-32s should be good, then low range should be pretty good with the auto and light weight. The only problem is Sami cases are getting hard to find. I had 2 stashed for a reason, but they're gone
Might just do the 4.24s and the 5.13s since they're drop in. Or a doubler to a Toyota case then I'd have 1.8/2.28/4.1 with the ability to gear either case.
|01-25-2019 09:56 PM|
|2big bronco||I would buy the $200 hoopty sidekick from 2bb and install the 2.0 in my/your samurai with your 3spd. Then with all the extra power and the auto realize you dont really need a standard low range and just run the trackick case that came with it combined with 3.0 gears|
|01-25-2019 03:51 PM|
Basic description of rig: '83 SJ410T, 4 link/radius arm 100" WB, Suzuki based axles, too heavy.
Transfer case(s): 6.4TT gears, TT Twisted T shift rails
R&P: 5.13 (more on that in a minute)
Type of wheelin you do: Technical trails
How you like it on the highway: It's a tiny bit too low geared - 3700rpm at 62MPH
How you like it offroad: Too low.
If you had to do it again whats gears would you buy: I'd stay with the 6.4's, but run taller R&P. I'm swapping in 4.6 now which will drop me to 3330 on the highway and loosen the converter up off road a little. At the moment the converter basically won't slip off road.
Photo of vehicle for reference.
Currently also taking weight out and lowering it.
|01-23-2019 08:46 AM|
Basic description of rig: Samurai, diesel swapped, stretched 18", steel flatbed, lot heavier than stock.
Engine: 1.9 TDI
Transmission: Geo tracker 5 speed
Transfer case(s): Geo tracker, twin sticks, 4.24 gears, slip yoke eliminators.
tire size: 33x12.5x15, worn out, actual measurement currently, 31.25"
Type of wheelin you do: Rocks, mild trails, Moab, other Utah wheeling, etc.
How you like it on the highway: high range is too high with the 3.73's and 33's, I went with the tracker tcase to try to lower my high range RPM's at high way speeds, but it's just quite a bit too low.
How you like it offroad: Does good offroad, climbs easily without much if any throttle.
If you had to do it again whats gears would you buy: I'm planning on swapping in 5.13 gears in the very near future, in order to be able to daily it a little better.
|01-22-2019 10:40 PM|
|This thread has more than 25 replies. Click here to review the whole thread.|