Pirate4x4.Com : 4x4 and Off-Road Forum - Reply to Topic
 
Pirate4x4.Com : 4x4 and Off-Road Forum  

Go Back   Pirate4x4.Com : 4x4 and Off-Road Forum > General Tech > General 4x4 Discussion > Tips for picking up a barnfind 1950 CJ3a
Notices

Thread: Tips for picking up a barnfind 1950 CJ3a Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Pirate4x4.Com : 4x4 and Off-Road Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.

** A VERIFICATION EMAIL IS SENT TO THIS ADDRESS TO COMPLETE REGISTRATION!! **

Email Address:
Insurance
Please select your insurance company (Optional)

Log-in


Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-25-2019 02:57 PM
FrankenRover Success. It rolled fine. A harbor freight come a long and sweat and it was on the trailer.
05-24-2019 02:51 PM
plym49 I don't see how you would run into trouble regardless, with that small and light vehicle.

Use a rope or tow strap to move it from where it is to wherever it is flat and open. Then load onto the trailer. Any comealong will be fine.

You don't even need ramps. Jack up one end with a bottle jack, jackstands or cement blocks behind the wheels, and back the trailer under it.

Now you can drag - skid onto the trailer with the comealong. THin scrap plywood under the tires as a skid if the wheels are locked, which they wont be after flat towing/dragging it first.

Repeat for the rear if needed. Trailer on hitch, tow vehicle in neutral, comealong the tow rig backwards to the Jeep.

That is worst case if locked wheels - flat tires - no ramps.

You'll be fine.

Congrats on finding your dad's Jeep!
05-24-2019 12:17 PM
newracer Personally I'd get a winch for the trailer, they are not that expensive. I wouldn't try to start it either. Just drag it on the trailer and work on it at home.
05-24-2019 11:26 AM
Treeclimber Bring a small compressor to inflate the tires and a come-along.

Expect everything to be bad, but, that the engine will turn over and run with starting fluid.

Expect clutch to be froze, brakes to be froze, brake lines to be rotted, fuel lines to be junk, fuel tank to be rotted, rust everywhere.

Been there, done this.

Also, it's been a while, but if memory serves me correctly, left hand lug nuts spin the opposite direction as right hand lug nuts. So if you're swapping tires be aware. (My dad's jeeps is late 1940s)
05-24-2019 10:50 AM
friskydingo
Quote:
Originally Posted by ChiScouter View Post
I would expect the brakes to be locked up. I would bring along a set of tires pumped up a bit over max psi and plan on dragging it up on the trailer. I would do what I could to make my ramps and trailer deck a slick surface to easier slide over. It could be dish soap and water in a hudson sprayer. I would want something more than a 1.5 ton come along to drag it.
Yeah, definitely grab a bigger one, like this

https://www.harborfreight.com/8000-l...ler-69855.html

Sent from my SM-J337V using Tapatalk
05-24-2019 09:32 AM
ChiScouter I would expect the brakes to be locked up. I would bring along a set of tires pumped up a bit over max psi and plan on dragging it up on the trailer. I would do what I could to make my ramps and trailer deck a slick surface to easier slide over. It could be dish soap and water in a hudson sprayer. I would want something more than a 1.5 ton come along to drag it.
05-24-2019 09:14 AM
Bones Be time ahead by calling a rollback to recover it, load it on the flatbed, then back your trailer up to him and transfer Jeep onto yours.
05-24-2019 09:10 AM
friskydingo As long as you can get the trailer ramps up to it you should be fine with a come along, worst case scenario and it's on flat tires with locked up brakes and sunk up to axles, eleven then an 8k come along should be able to pull it out with some sweat and time


Sent from my SM-J337V using Tapatalk
05-24-2019 09:09 AM
Beat95YJ Bring air/co2
05-24-2019 09:00 AM
FrankenRover
Tips for picking up a barnfind 1950 CJ3a

Hey folks.

Iím going to Montana in a few weeks to pickup a 1950 CJ3a that belonged to my dad when he was a teenager. We tracked it down to an old relative that lives there and it has been sitting in a field covered for many years.

Likely it doesnít run.

Whatís the likelyhood it wonít roll? I can get some roller wheels and tires.

I have no winch on the trailer. If it rolls, is a come-a-long good enough to get it up on the trailer? Ratchet strap instead?

What would you take with you to go pick it up? Iím planning to take my trail tool set, CO2 setup, spare battery (if the starter works and the engine is not seized it will at least move).

Thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -7. The time now is 08:19 PM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 ©2011, Crawlability, Inc.
User Alert System provided by Advanced User Tagging (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.